Key Torque and Volume Specs
#1
Thread Starter
Key Torque and Volume Specs
Here's some key torque and volume specs that I find handy
--80 lb-ft wheel lug nuts
5.1 qt engine oil
--29 lb-ft drain plug
--16 lb-ft oil filter
1.56 qt transmission fluid
--29 lb-ft drain plug
--33 lb-ft filler plug
0.78 qt differential lube
--33 lb-ft drain plug
--33 lb-ft filler plug
6.9 qt radiator coolant
These are from the AP1 shop manual.
Thanks NVMY4N. I added the note above about AP1.
**********
Split and Edited Title
--80 lb-ft wheel lug nuts
5.1 qt engine oil
--29 lb-ft drain plug
--16 lb-ft oil filter
1.56 qt transmission fluid
--29 lb-ft drain plug
--33 lb-ft filler plug
0.78 qt differential lube
--33 lb-ft drain plug
--33 lb-ft filler plug
6.9 qt radiator coolant
These are from the AP1 shop manual.
Thanks NVMY4N. I added the note above about AP1.
**********
Split and Edited Title
#5
Registered User
Originally Posted by Twiztid,Dec 8 2007, 07:29 PM
For Tranny Bolts
94 ftlbs for the flywheel to crank
19 ftlbs for the pressure plate to flywheel
All the larger Tranny bolts are 47ftlbs ( 17mm socket )
The two bottom smaller ones are 33ftlbs ( 14mm Socket)
The three that hold the cross member under the shifter are 28ftlbs (14mm socket)
The front subframe .. the four larger ones are 86ftlbs ( 19mm socket ) the two smaller ones are 43ftlbs ( 17mm socket )
All the 6mm ( 10mm socket) around the shifter boots top and bottom are 7 ftlbs
The 8mm drivshafts bolts 24ftlbs ( 6mm allen )
94 ftlbs for the flywheel to crank
19 ftlbs for the pressure plate to flywheel
All the larger Tranny bolts are 47ftlbs ( 17mm socket )
The two bottom smaller ones are 33ftlbs ( 14mm Socket)
The three that hold the cross member under the shifter are 28ftlbs (14mm socket)
The front subframe .. the four larger ones are 86ftlbs ( 19mm socket ) the two smaller ones are 43ftlbs ( 17mm socket )
All the 6mm ( 10mm socket) around the shifter boots top and bottom are 7 ftlbs
The 8mm drivshafts bolts 24ftlbs ( 6mm allen )
#6
Registered User
Anyone know the torque spec for the caliper bolts to the control arm? I am replacing my rotors and wanted to check what I should torque those bolts back to.
#7
And the value is 79.6 ft lbs
Sent from my iPhone using Tapatalk
Trending Topics
#8
I get my values from this post a bit more comprehensive
Torque Specs - S2KI Honda S2000 Forums : https://www.s2ki.com/s2000/topic/500969-torque-specs/
Sent from my iPhone using Tapatalk
Torque Specs - S2KI Honda S2000 Forums : https://www.s2ki.com/s2000/topic/500969-torque-specs/
Sent from my iPhone using Tapatalk
Thread
Thread Starter
Forum
Replies
Last Post