Originally Posted by andrewhake

Again thanks for the info. How many threads engaged on that max free length measurement? Did you measure the max length with standard mount? (Just checked, looks like according to Ohlins the max recommended free length is ~435mm.)

Very cool that a shorter and higher ride height is actually possible compared to the standard mount. The design of the standard lower mount definitely leaves a lot of room for adjustment on the table with how much space there is between the actual mounting point (bolt holes) and the end of the threaded area. So this mount allows the actual damper body to get much closer to the mounting point itself.

Definitely post up once you have a sample of the anodized version!

Originally Posted by //steve\\

I feel like the cheapest alternative and probably adequate space for adjustment would have been to just make a new lower fork (only the removable fork part). There is a good 10-15mm worth of height that could have bene removed from that piece. I can't see people needing to go much lower than what that would allow. Obviously you already have your solution but just my 0.02 cents.

Originally Posted by Apex1.0

Designing and manufacturing solutions for customers and enthusiasts... Thank you Sake Bomb Garage!

Organizations like this are invaluable to support the future of the s2k community.

Originally Posted by andrewhake

Looks good! A little odd to have a rotary logo on an S2000 part though. :P