Milltek Exhaust Group Buy - HendyPerformance
#141
Yes I've managed to take them off as well, same technique.
The stock pre-facelift rear rubber hangers is definitely not suitable for the Milltek boxes, I had to make new ones to get the tailpipes sit correctly.
The stock pre-facelift rear rubber hangers is definitely not suitable for the Milltek boxes, I had to make new ones to get the tailpipes sit correctly.
#142
Did any of you guys need to use some kind of exhaust paste on the slip joints to keep it from leaking?
I can only run mine for a short while in the garage but can feel it leaking quite a bit so far.
Hoping it might seal itself after a few miles of hard use.
I can only run mine for a short while in the garage but can feel it leaking quite a bit so far.
Hoping it might seal itself after a few miles of hard use.
#144
Had to use holts exhaust sealer on my milltek on the joints as all were blowing, no matter how many times i adjusted them, i quizzed miltek about it and they said its common practice and expected to need to use it. First exhaust i have installed so i took their word for it.
when i say blowing, water vapor was leaking out.
when i say blowing, water vapor was leaking out.
#147
UK Trader
Thread Starter
We have limied stock of the duals if you still want one of those. Also the HKS singles are in stock also (these are about to be subject to another price increase via HKS)
Si
#148
Cheers Si, yes it was the Single AP2 that I and a few others originally wanted them to manufacture that started this idea off lol .
How many more Singles would we need to get them to make them up?
They should be willing cnsidering the business we've just given them?
How many more Singles would we need to get them to make them up?
They should be willing cnsidering the business we've just given them?
#149
UK Trader
Thread Starter
I have your PM - I will reply this evening - been in meetings all day and a bit behind!