Engine won't start error code: p0335
#1
Engine won't start error code: p0335
Just replaced timing components. Trying to start engine and getting crank position sensor signal error (P0335)
But the car is logging rpms while attempting to turn the engine over.
Checked for voltage in the pins off the harness had 5 volts ground and 12 volts on the positive ends
Running V2 Kpro.
Car is a 2004 ap2.
Car was running before we took it apart.
Any thoughts on a resolution?
But the car is logging rpms while attempting to turn the engine over.
Checked for voltage in the pins off the harness had 5 volts ground and 12 volts on the positive ends
Running V2 Kpro.
Car is a 2004 ap2.
Car was running before we took it apart.
Any thoughts on a resolution?
#4
Check the small Hondata provided harness. Mine had pins that were not crimped properly , pull each wire and see if the wire comes out easily,if so then recrimp the wire onto that pin
Thread
Thread Starter
Forum
Replies
Last Post