S~Factor's Splitters and Diffusers
#1
Thread Starter
S~Factor's Splitters and Diffusers
Please check the last page for the latest.
Here's a good read regarding splitters and aerodynamics: https://robrobinette.com/S2000Aerodynamics.htm
Thanks for stopping by.
Ray
516-375-7899
Here's a good read regarding splitters and aerodynamics: https://robrobinette.com/S2000Aerodynamics.htm
Thanks for stopping by.
Ray
516-375-7899
#2
Thread Starter
First up, Jimels Hard Top
I found this on the first page of the hardtop manual. I thought it was funny.
Next up, CarbonS2000
ASM rear over fenders and Tein coilover install.
Sorry no actual pictures of the coilover installation.
I found this on the first page of the hardtop manual. I thought it was funny.
Next up, CarbonS2000
ASM rear over fenders and Tein coilover install.
Sorry no actual pictures of the coilover installation.
Trending Topics
#8
Ray, did you hammer the metal in on the driver's side for the hardtop? When mine was installed, no hammering was done, so as a result the striker is screwed in with two of the three, and the third is a bit lopsided. It sits fine though. Oh, and Jimel, get some shin-etsu grease for the top, and look into either putting cardboard or electrical tape on the latches to reduce creaking.
#9
Community Organizer
Originally Posted by BD89,Jan 26 2008, 10:53 PM
Ray, did you hammer the metal in on the driver's side for the hardtop? When mine was installed, I didn't do any hammering, so as a result the striker is screwed in with two of the three, and the third is a bit lopsided.
#10
Originally Posted by freq,Jan 26 2008, 10:57 PM
Did you read the instructions? They plainly state: