Haltech Platinum PRO Plug In ECU for Honda S2000 AP1! MVP Motorsports
02-24-2012, 09:52 AM
#1
Former Sponsor
Thread Starter
Join Date: May 2007
Posts: 3,717
Likes: 0
Received 0 Likes
on
0 Posts
Haltech Platinum PRO Plug In ECU for Honda S2000 AP1! MVP Motorsports
Features:
Direct plug and play replacement of the OEM ECU, no re-wiring necessary.
Uses the cars factory sensors
Supports Honda_s VTEC Control
Supports Sequential Injection (peak and hold) and Direct fire ignition
Windows 2000, XP, Vista, Windows 7 compatible software
Real time programming, instant hesitation free adjustment while engine is running
Fully user definable 32 x 32 mapping
Tuning via Volumetric Efficiency (VE), Injection time or Lambda Correction (MAF)
Diagnostic trouble code storing & Check engine light control(Access through laptop only )
Selectable onboard internal MAP sensor rated to 150kPa (up to 1.5 Bar or 22psi boost)
Wideband _auto tuning_ using user definable target AFR table
USB and CAN Communication Port
Factory Outputs:
4 x Fuel Injector outputs
4 x Ignition outputs
VTEC, Coolant Gauge, AC Clutch Relay, Idle Control
Thermo Fan, Check Engine Light, Fuel Pump
Factory Inputs:
MAP sensor, Throttle Position Sensor, Knock Detection sensor,
Coolant Temperature sensor, Vehicle Speed Sensor,
Air Temperature sensor, Power Steering Switch, Narrowband Oxygen sensor
Expansion I/O*:
2 x Analogue Voltage inputs
2 x Analogue Temperature inputs
4 x Digital Outputs
*Optional auxiliary harness required to be purchased Haltech Part # HT040003
Functions:
VTEC On _ INJ / IGN Tables
VTEC On _ CAM Table
Closed Loop O2 Control
Decel Cut Over Boost Rev Limiter
Closed & Open Loop Boost Control
Gear Setup
Transient Throttle Enhance
Knock Control
Long Term Fuel Trim
Correction Tables: Fuel Ignition Boost:
Cranking
Air Temp Target Correction
Zero Throttle Gear Correction
Cylinder Trim
TPS Correction
Generic Correction 1
Generic Correction 2
Gear Correction
Post Start
Air Temp Duty Correction
Post Start
Miscellaneous:
Data Logging: 448Kb of onboard data logging, Storage for approx 40 minutes at 10 logs per seconds,
6 channels of data
Max 20 channels logging capability
Tune can be password protected in software
Rugged anodized aluminum casing
Power Requirements:
Source: 8.6 to 16.5 Volts DC
Consumption: 530mA @ 12Volts DC
Physical Dimensions:
ECU Dimensions Length: 154mm (176mm with MAP nipple)
Width: 158mm Height: 42mm Weight: 680g (1.5 lb)
Applications: Honda S2000 (AP1)
The Kit includes:
Pro Plug-in ECU, USB Cable, Programming Software CD, Quick Start Guide, Instruction Manual (on CD)
PM OR POST UP TO GET YOUR S2KI SPECIAL PRICING!!
Regards,
Robert
