2000 PY Integra Type R 00-1142
07-27-2018, 01:56 PM
#81
I never realized how much work goes into this swap. Progress is looking good, I also like the icebox intake, did it change the sound very much ? I modified the stock intake to suck air from the passenger fender, still a bit too quiet for me, though intake temps are much cooler.
07-28-2018, 04:17 PM
#84
Looks good. I do like it and it looks like you will get more air flow through the engine bay and brake ducts for track car. Perhaps better overall lighting output too ?.
It looks vastly different than the USDM version, too bad you can't have one of each, lol. USDM looks smaller and sleeker to me, JDM looks more blocky and upright. I like the fender corner lights, will look good with a red emblem.
It looks vastly different than the USDM version, too bad you can't have one of each, lol. USDM looks smaller and sleeker to me, JDM looks more blocky and upright. I like the fender corner lights, will look good with a red emblem.
Last edited by zeroptzero; 07-28-2018 at 05:16 PM.
07-29-2018, 08:14 AM
#85
Thread Starter
I still have the stock panels but i'll likely sell them off. I never liked the look and much prefer the JDM.
I'll start fielding quotes in the next few weeks and hopefully have her painted up by end of next month.
I'll start fielding quotes in the next few weeks and hopefully have her painted up by end of next month.
10-12-2018, 05:02 PM
#89
Is that a Mugen header ?, if so did you notice much of an improvement over the stock header ?
I love the Mugen exhaust. I shoehorned the Mugen twin loop muffler onto my integra and absolutely love it, nothing beats it IMO.
I love the Mugen exhaust. I shoehorned the Mugen twin loop muffler onto my integra and absolutely love it, nothing beats it IMO.
10-12-2018, 05:30 PM
#90
Thread Starter
No it's a TODA rep header that i picked up on ebay. Buddy made good power with it so i figured why not.