Mark this thread as Unsold
CA Ap1 2003 Honda S2000 Turbo
#1
CA Ap1 2003 Honda S2000 Turbo
Christian
21,500 firm
located in San Francisco Bay area
cisheehan@aol.com
currently registered, clean title
Up for sale:
2003 Honda S2000 Ap1
-63,XXX miles
-405whp
-precision Turbo
-Built motor
-Soft top in perfect condition
-Pearl white paint
-Just had major retune and overhaul
-All running aspects of car were inspected and updated as needed.
-AEM v2
-Full exhaust (single exit)
Inside:
-Stock Cams
-ST Valve Springs and Retainers
-HBeam Rods
-CP Pistons
-Sleeved
-oil squirters untouched
-ACT Clutch
Recent Changes:
-ID1000 injectors are installed less than 50 miles ago
-Intercooler and piping serviced and properly reinstalled
-replaced driveshaft bolts
-Boost controller line has been replaced and wiring checked
-Wide band o2 is good and calibrated to AEM V2
-Turbo Intake/filter brand new components
-new Battery
-Exhaust serviced and leak fixed
-Transmission fluid and diff fluid checked
-Oil changed in last 50 miles
-fuel pumps replumbed and wiring tucked.
Overall my car is pretty clean. Minor projects in my eyes include:
-fixing the front right headlight flicker
-Getting front bumper fitment correct and touching it up. (CoupleRock chips)
-Finding a heat shield that will protect hood from turbo heat. I.e. Turbo blanket.
(Previously has run e85 and made 500whp with ID2000 injectors. I removed the flex fuel components and replaced the injectors with ID1000 and tuned it for the street and longevity.)
21,500 firm
located in San Francisco Bay area
cisheehan@aol.com
currently registered, clean title
Up for sale:
2003 Honda S2000 Ap1
-63,XXX miles
-405whp
-precision Turbo
-Built motor
-Soft top in perfect condition
-Pearl white paint
-Just had major retune and overhaul
-All running aspects of car were inspected and updated as needed.
-AEM v2
-Full exhaust (single exit)
Inside:
-Stock Cams
-ST Valve Springs and Retainers
-HBeam Rods
-CP Pistons
-Sleeved
-oil squirters untouched
-ACT Clutch
Recent Changes:
-ID1000 injectors are installed less than 50 miles ago
-Intercooler and piping serviced and properly reinstalled
-replaced driveshaft bolts
-Boost controller line has been replaced and wiring checked
-Wide band o2 is good and calibrated to AEM V2
-Turbo Intake/filter brand new components
-new Battery
-Exhaust serviced and leak fixed
-Transmission fluid and diff fluid checked
-Oil changed in last 50 miles
-fuel pumps replumbed and wiring tucked.
Overall my car is pretty clean. Minor projects in my eyes include:
-fixing the front right headlight flicker
-Getting front bumper fitment correct and touching it up. (CoupleRock chips)
-Finding a heat shield that will protect hood from turbo heat. I.e. Turbo blanket.
(Previously has run e85 and made 500whp with ID2000 injectors. I removed the flex fuel components and replaced the injectors with ID1000 and tuned it for the street and longevity.)
Thread
Thread Starter
Forum
Replies
Last Post