IL: 2002 turbo s2000
 

$20000 obo
Decatur Illinois
jaredcothren1@gmail.com
Jared
217-520-8378
Benson Sleeved F20C

88mm 10.5:1 CP PISTONS W/UPGRADED WRIST PINS

Pauter rods

Stock crank with OEM bearings

Inline pro chain tensioner

ARP head studs


4Piston cnc ported head

Ferrea valvetrain


Synapse Motorsport Turbo kit

GTX4294r (70.3mm)

4" downpipe and exhaust

Twin Tial MV-R waste gates

Tial Q BOV

Garrett core 24x12x4 intercooler


Inline Pro r200 rear end

Competition clutch twin disk

Stock ignition

RPM T56 GForce 1-4 Gearset, Liberty faceplated Dogbox (has 5th & 6th gear, and reverse)


Double 044 fuel pumps fed from a surge tank.

Walbro 255 feeds the surge tank

AEM Infinity EMS (also have a hondata K Pro for this setup)

ID2000cc injectors

Aeromotive fuel pressure regulator

Inline Pro intake manifold


Forbidden Mugen style carbon fiber roof with lexan rear window (single sided carbon) 9/10 condition


Whitfield 10 Point Roll cage (ready to install)


I have all of the factory interior panels and pieces, but a lot were uninstalled to test fit the roll cage. The AC/heater assembly on the passengers side has been removed, but is fully intact and in working condition. All of the interior pieces come with the car upon purchase buy are not installed.


3M 1080 series matte aluminum gray vinyl wrapped (2 years on the car, always garaged). Car would need a paint job if removed as it was not in the best shape. Factory paint is black.


The T56 Transmission and the 4Piston Head work, only has about 200-300 miles on it, like new.


The only real issue is that the manifold is cracked and the car cannot reach its full potential until it is replaced. It has been repaired but keeps cracking. It also does not have the speed sensor for the T56 transmission... So, no working speedometer. Contact Jared for any questions.
2175208378


https://cimg2.ibsrv.net/gimg/www.s2k...2c3576a4c1.jpg
https://cimg7.ibsrv.net/gimg/www.s2k...296d3b90f0.jpg
https://cimg4.ibsrv.net/gimg/www.s2k...d737ec282c.jpg
https://cimg9.ibsrv.net/gimg/www.s2k...7ecb757114.jpg
https://cimg2.ibsrv.net/gimg/www.s2k...cfa1229bef.jpg

Please update with the required template and into.

https://www.s2ki.com/forums/member-s...tings-1074910/

If you end put parting this car out. I'd be interested in the T56 setup

What’s the whp?

https://cimg1.ibsrv.net/gimg/www.s2k...10e61f69f1.jpg
this was from 1/4 roll racing. On the Dyno the runner could only get it to around 25psi 650hp before spinning the tires we turned it up to 35psi at the track I was thinking around 800ish