Mark this thread as Unsold
FS: TiAL 38mm Wastegate (Polished)
#1
Registered User
Thread Starter
FS: TiAL 38mm Wastegate (Polished)
TiAL 38mm Wastegate (Polished) w/ 7lb spring
Came with the revhard kit i bought. I had the wastegate on for about a month.
Long story short:
- I had an exhaust leak for about a month that i couldnt figure out
- Realized there was air coming from the wastegate and i had a cracked gasket.
- Replaced the gasket... then the leak got even worse...
- So I eventually ordered a new w/g so i wouldnt have any downtime when i took this one off to figure out what was wrong with it.
- Turns out, it was only missing a valve seat (metal ring that sits between where the wastegate meets the manifold)
So all you need is a valve seat and you'll be golden!
Asking for 130 Pick-up!!!
You can see from the diagram on the left where the valve seat is located (very bottom)
Came with the revhard kit i bought. I had the wastegate on for about a month.
Long story short:
- I had an exhaust leak for about a month that i couldnt figure out
- Realized there was air coming from the wastegate and i had a cracked gasket.
- Replaced the gasket... then the leak got even worse...
- So I eventually ordered a new w/g so i wouldnt have any downtime when i took this one off to figure out what was wrong with it.
- Turns out, it was only missing a valve seat (metal ring that sits between where the wastegate meets the manifold)
So all you need is a valve seat and you'll be golden!
Asking for 130 Pick-up!!!
You can see from the diagram on the left where the valve seat is located (very bottom)
Thread
Thread Starter
Forum
Replies
Last Post