Honda Paintless Dent Repair Specialist in Atlanta?
#1
Registered User
Thread Starter
Join Date: Mar 2005
Location: Near Atlanta, GA
Posts: 155
Likes: 0
Received 0 Likes
on
0 Posts
Honda Paintless Dent Repair Specialist in Atlanta?
Looking for a lead on a Paintless Dent Repair tech in the Atlanta area who is familiar with dent repair on panels where Honda's rubberized "meltsheet" sound insulation materials have been applied to the underside of the fender panels.
My PDR guy initially thought removal of a couple moderate-sized dents on the left front fender and right rear fender of our recently acquired Honda S2k would be no problem... then he ran into Honda's meltsheet.
Apparently the meltsheet isn't a complete undercoating and as luck would have it, the edge of the meltsheet fell under the dents or something like that. Moreover, in addition to being a challenge to work through, removal of the meltsheet to make the PDR process easier is also not necessarily an option regardless of access issues.
He was able to improve the finish but was reluctant to work the panels too hard for fear of pushing the sheet metal past the original outer mold line.
My PDR guy initially thought removal of a couple moderate-sized dents on the left front fender and right rear fender of our recently acquired Honda S2k would be no problem... then he ran into Honda's meltsheet.
Apparently the meltsheet isn't a complete undercoating and as luck would have it, the edge of the meltsheet fell under the dents or something like that. Moreover, in addition to being a challenge to work through, removal of the meltsheet to make the PDR process easier is also not necessarily an option regardless of access issues.
He was able to improve the finish but was reluctant to work the panels too hard for fear of pushing the sheet metal past the original outer mold line.
#3
Registered User
Thread Starter
Join Date: Mar 2005
Location: Near Atlanta, GA
Posts: 155
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by c17r15,Apr 27 2005, 01:58 PM
would like to know also.....i have 2 dings in the rear driver quarter.
Of course, the key is to have a PDR tech give you an assessment / estimate and get their take on how do-able the PDR repair will be. Again, the dings on the S we bought for my wife were no-kidding dents caused by falling objects or someone sitting on the front fender, not door dings. The smaller dings would seem to be easier to deal with, particularly if you haven't polished off the clear coat orange peel.
#4
i had a ding on my front fender which was removed in 15min and cost $35. it was on wade green road in kennesaw. go north on 75 and get off on exit 273 (wade green road). go right. go about 3/4 mile on the right is a blockbuster and taco bell. this place is located between the two. great job says PAINTLESS DENT REMOVAL and HAIL DAMAGE
Thread
Thread Starter
Forum
Replies
Last Post