I have a set of 8.75mm wheel spacers custom made specifically for the S2000 out of CNC 6061-T6 billet aluminum. These will fit the front wheels only. They're hubcentric with a 70mm inner bore and the outer diameter is flush with the stock rotor hub so there's no gap between the wheel and hub. The lug holes are also the same size as the lugs and all the edges are bevelled so everything fits snug. H&R only make spacers in 5 and 15mm so these are perfect if you need something in between but these will fit much better than anything off the shelf. I mounted them once as a test fit so they're in pretty much new condition except for a little dirt from my wheels and hub.

I paid $130 for these. Looking to get $80 shipped.

 

nice hubcentric spacers

 

bump!

 

Still collecting dust!

 

Man these would be perfect once I actually get my wide body on. Hmmm... I just wish you were selling these next spring

 

man that's a long project! how about buying them now so you'll have them when you need them later...

 

will these clear spoon calipers with CE28n 17x7.5 +50?

 

I can't tell you for sure. Try getting some of those ghetto 5mm and 3mm spacers at pep boys and stack them up for a test fit. I wouldn't drive with them of course.

 

I doubt it. I am running Work Emotion CR Kai's with +48 offset and a 10mm spacer. Youll probably be very very close to the caliper if not touching i would think.

BUMP!!!

 

you need 12mm spacers to be exact.