Hi I am pretty excited about getting started on my locost (loutus 7 replica) project, but not as excited about parting my car out. I think the prices I have listed are pretty fair as far as what these parts should go for. So...consider the prices below general guidlines of what I think the parts should go for. I can give you a better deal though, especially if you can get a bunch of stuff out of my garage. Let me know if you think something is priced too high, I'm sure I can match what you've seen/give you a reasonable price.


s27sam@yahoo.com





locost project with complete '02 s2k drivetrain for $5600 (includes drivetrain 42k miles, racing seats start of frame, ....)
see pics at http://www.locostusa.com/forums/view...hp?f=40&t=5827

BUY EVERYTHING ON THIS LIST BELOW FOR $1000 including the rest of the "chassis" !!!!


Rear half of wrecked chassis, good windshield and drivers quarter panel $450
Roll bars (both sides) $50
Convertible Top Motors (price for 2 motors) $75
Air Conditioner/Heater Boxes (behind dash in car+all ducts) $100
ABS Control Module $50
Blue Upper Console between seats (small crack on interior) $30
Gas Cap Door $15
Trunk Interior Panelling (All Pieces) $75
Wiper Motor $25
Wiper Arms and Blades (both) $25
Air Box Filter $10
Plastic Roll Bar Covers 2 x $25 = $50
Driver and Passenger Floor Mats 2 x $15 = $30
Plastic Shield Outside Windshield $10
Jack Kit with Foam and eye bolt $25
Foam Firewall Pad $15
Trunk Gasket $10
Radio Cover/Vents $25
Auto Cruise "Black Box" behind steering wheel/dash $50
Passenger Side Door Panel (sold) Driver (cracked) $10
Door Handles (that attach to door panel) (both) $10
Driver Power Window/Mirror Controls $20
Passenger Power Window Control $10
Roof Open Switch $15
Driver and Passenger Sides of Windshield Column Plastic $20
Rear View Mirror $35
Hood Release Lever $5
Gas Tank Filler Tubes with Cap $25
Drivers and Passenger Window (both) $100 or $50 each if you only need one
Plastic Pieces Behind Door latch (interior) (both) $15
Driver and passenger "knee rest pads" (both) $20
Pass Door Sill (partial crack) + Driver Door Sill (slight scrapes) $25
Dash (blue w/o airbag section) Sold
Black Center Console (including shift boot) SOLD
Wind Deflector SOLD
Rear Tail Lights SOLD
Plastic Behind Boll Bars (where convertable top sits) SOLD
Driver and Passenger Footwell Plastic (both) SOLD
Tweeter Covers (both) SOLD
Plastic Dash (around speedometer etc) SOLD
Seatbelts (charges spent) (both includes male and female side) SOLD
Convertible Top (glass with defrost, frame and canvas) SOLD
blue Seats (no scratches, tears, marks, or cracking) SOLD
Exhaust (behind Cat, scraped up some but fully functional) SOLD mufflers
Headlight Ballast SOLD
Steering Wheel Sold
(blown airbag, includes. plastic, and cruise switches) still available
Antenna Base SOLD
carpet SOLD (floor mats still available)
Power Steering rack and controller SOLD
Window Motors (price per motor) SOLD
Front subframe SOLD
Front lower A arm Right or Left SOLD
Front upper A arm Right or Left (with balljoint) SOLD
blue leather center section that covers trans mission tunnel SOLD


Small Parts that would be included, but I have not set a price for yet
Radiator top mounts,"Engine Shield", "Engine Bay Black Shield", Bottom Half of airbox, Metal Braces Behind Dash, "leg" cargo net, Trunk Flapper Vent, Dead Pedal/Foot Rest, Air Vent Director, Door Lock/handle, Gas Pedal Stop, Blown Passenger Airbag, "Glove Box" in front of Passenger (crack in bottom), ...... There are some more exterior pieces that I need to go through which will be for sale, but I haven't sorted them out yet.

I think the prices I have listed are pretty fair as far as what these parts should go for. But, buy a bunch of stuff and get a discount!!! All prices are without shipping or Paypal(3%) which you would need to add in the actual cost if you want to use those.

If someone Wanted to buy everything off of me to part out themselves I would be willing to take a bulk price deal ($1000) It would fit into the bigger Uhauls, and I have equipment that we could use to get anything you need loaded. I have done quite a bit of work separating everything and I have digital pics of all of the parts listed above, most from two directions. All of the smaller parts are stored in labeled tubs.
I am located in Xenia Oh (near Dayton between Cincinnati and Columbus)
Let me know if you have any questions
Sam
s27sam@yahoo.com

 

more pics of the rolling chassis... how badly is the frame / structure damaged?

 

e-mailed

-chris

 

damn I've been waiting for a softop forever i bought a hardtop last week, because i got tired of waiting so long GL with sale

 

how much the soft top would cost shipped to 70605.. thank

 

emailed.

 

Can i by any chance have your rear left fender? (the one facing us in the first pic) let me know.

 

Hi, Sorry, I cannot remove the rear fenders.

I'll post a few more pics of the chassis, but the frame was not damaged at all in the front, just the body work and the piece that holds the radiator. The rear passenger side had the wheel ripped off, breaking the a-arms. This did not damage the subframe, and I have already purchased all of the suspension and brake parts to put it back together except the wheel itself. The only damage to the frame if you can call it that is the back of the passenger side rocker panel, and the wheel when it was coming off dented the inner fenderwell which can be seen in the trunk. I'll post a few pics that show everything.
Thanks,
Sam

 

Hi here are some pictures of the chassis and the seats

 

Hi I got a shipping quote from OH to Los Angeles CA assuming it weighs 75lb for $156 if you are ready to buy the top I'll box it up and weigh it and get an accurate quote otherwise I don't want to go through the effort to box it up in case someone buys it locally. I measured and it should fit into a box 60x30x12
Thanks,
Sam