Mark this thread as Sold
Recaro Pro Racer HANS Seat.
Thread Starter
Joined: Feb 2008
Posts: 4,580
Likes: 2
From: Fresno, CA
Recaro Pro Racer HANS Seat.
Name: Rob Burch
Location: Fresno, CA
Please check my feedback from previous transactions here..... rob.ok feedback
More pictures available on request for any item(s).
Recaro Pro Racer SPG HANS.
$900.00 Plus Shipping, Or Trade + Cash For Recaro Pole Position!
FIA Standard 8855-1999. Manufactured in June of 2008. This seat can be used legally without a set back brace until the end of 2013 (which is when 1999 standard is outdated).
The seat is in overall good condition. There is a burn / rip under the "R" on the head rest. There is also a very minor split near the bottom of the left bolster. I will be sowing this up to prevent it from spreading. The tear can not be seen with the bottom cushion in place.
The bottom cushion has had most of the foam shaved out to lower my total head height. If it is uncomfortable...tough luck...buy a new one from Recaro. Some of the original foam was also removed on the leg side bolsters to fit me better. I will reinstall the foam just like it was from the factory.
Shipping for this item is VERY expensive due to its size. I would prefer not to ship if possible. For any local CA residents, I maybe able to deliver....
As of right now my custom modified seat rail is not for sale.
Race Technology ECU Interfaces » Serial Interface for AEM EMS
$150.00 Shipped!
For use with a Race Tehcnology DL1 Data Logger, and or a Dash2 via serial interface with a AEM EMS. Contact me for more information.
http://www.race-technology.com/upload/prod...ages/ECUInt.jpg
Many other OEM items available. Please inquire if you are looking for anything.
All items for sale will be listed here. If it is not listed it is not for sale. Prices are firm and fair. Thank you!
Looking for feedback from previous transactions? Look here......rob.ok feedback
Thread Starter
Joined: Feb 2008
Posts: 4,580
Likes: 2
From: Fresno, CA
Originally Posted by aCab,May 17 2010, 12:40 PM
you can run those spacers without the studs, correct?
To answer your question, I ran them without changing the studs on track with no problems. It can be done, but has a lot to do with the wheel design.... some wheels are thinker at the hub so it's hard to say yes or no.
-Rob
Thread Starter
Joined: Feb 2008
Posts: 4,580
Likes: 2
From: Fresno, CA
Originally Posted by suzukablueS2000,May 19 2010, 07:09 AM
^^ why are you selling those tires? is there a tire specific reason?
-Rob
Thread Starter
Joined: Feb 2008
Posts: 4,580
Likes: 2
From: Fresno, CA
Originally Posted by ideugene,May 24 2010, 07:37 PM
why are you selling the race tech interface cable? do you not like it? or are you changing applications?
-Rob
