These are big pieces and would be difficult to ship. They have recently been re-clearcoated and are in very good shape. The rear tray is in near new condition, the front has scrapes on the bellyside that have been clear coated. The carbon fiber is scratched only under the lip on the front tray, otherwise the scrapes in the rear of the front tray have left indents in the carbon, but not scratched it. The pictures taken show the worst of the scrapes, and it's near impossible to see on the car (you have to crawl under the car to see the damages). These pieces do not come clear coated from the factory, they are in untreated raw dry carbon form. Costs of clearcoating was $300 the first time they were clear coated. Anyways, here are the pics:


































Comes with needed mounting hardware. I don't think anyone else on the site has these pieces so they are pretty rare. They are fully functional aerodynamics pieces, the rear diffuser has a slope of 15 degrees ~ proper angle for a diffuser to slow the air flow. Open to offers, but these parts cost me over $3,300.00 after shipping and took about 4 months for delivery from Japan + the cost of clearcoating. Please no low ballers.

I don't think anyone else has these pieces.

1.The way it's mounted, you'll need to run the OEM front and rear tie bars.
2.The x-brace wont work with this unless it's very low profile (not like the spoon).
3.Yes, you'll need to drop the tray in order to change the oil, unless you have the drain valve with a hose attachment where you can redirect the oil drainage.
4.For the rear diffuser, the tray is uncut. You may cut it to whatever shape you want for your exhuast, I choose not to b/c the axle exhuast system costs $2300.

and some pics for what the trays look like on the car:




-ardy

 

pics not working

 

imagestation is not being friendly.

My apologies, please view the album:

http://www.imagestation.com/album/?id=4288656253

 

 

by any chance are you selling the wheels?

 

Hey Ardy, do you have any straight on shots of the rear piece mounted? Nevermind, I just saw it.

Question, how low does the rear piece hang?

 

If I can figure out how to make the rear work with my Comptech exhaust, I want to buy it. In your opinion, if I were to cut the part to allow for the mufflers and tips to clear, would this weaken the part signifficantly?

Also, I didnt catch- are you willing to split them up? I have the '04 front on mine so the front assy would be of no use to me.