Sold

I have a forsale a brand new Pioneer DEH-6800MP w/DCI and harness. Everything is wired up and ready for installation. This is completely plug and play...




Instructions:
1. Remove the radio door.
2. Remove the 4 screws that hold in the stock radio.
3. Unplug the HU and remove.
4. Switch the mounting tabs from the stock HU to the Pioneer.
5. Place stock HU on the shelf to collect dust....
6. Plug the harness into the car.
7. Tuck the DCI to the side.
8. Hook up VSS if desired... its the gray wire not taped up.
9. Plug in the Pioneer.(remove white plastic tab to plug in the DCI)
10. Screw it down with the 4 mounting screws.
11. Replace the radio door.
12. Turn on car and enjoy...


$355.00 / OBO

 

top

 

I don't suppose you want to sell the DCI seperately?

 

Nope, its all soldered into the harness.

 

Well free bump then!

 

 

Will this head unit work with the dash controls?

 

Yes I have pre-soldered the DCI to the harness. Its fully ready to go. Just plug it in

If you decide to purchase it I can walk you through the install over the phone so you can install it yourself.

 

How realiable is this with the adaptor for the side controls? Is there delay? Im asking because I hate the type of controls that respond like 2 seconds after you push. I like it factory style, instant.

 

Pending...