I wanted some fogs that were subtle, contained within the faux vent area, did not interfere with the airwalker lip on the car, and didn't overpower the whole front bumper. I was also looking for an easy install. I fabricated these in about an afternoon (minus drying time). I'd tried another style but after several failed attempts to make a mold of the vent area with the lip in place I went for this. I haven't done the final install because I'm still not sure I'm happy with the result.

 

Best fog light on an AP1 i've seen yet!

 

looks good

dayummm headlights look clean as well...did you remove the mold lines?

 

You did a great job, that takes some serious skill for it to come out that nice.

 

It's just the bad lighting that makes the headlights look so clean.

 

looks kinda like the light is pointing down though in that last pic. maybe just the angle of the pic? still, impressive job though!

 

Very nice, what is the mold made of?

 

i like em

 

nice, looks good. I'm surprised an aftermarket company hasn't released a set of fogs to fit the faux vents yet. All there is, is custom or bad fitting Si ones.

 

Very nice! Now setup a goup buy for those bad boys!

Jim