S2KI Honda S2000 Forums - WA: UPDATED 2/20 Garage Clean Up, Radar detector

Name: Elliott
Location Seattle WA Area
Contact: PM Me
Payment: Paypal prices include shipping within the US unless otherwise noted.

Time to clean out the pile of random parts in my garage

Passport Radar Detector $130
Brand new. I think I opened it once to look at it but never installed it.
Attachment 76654
Attachment 76655

Ohlins Springs $30 each $100 for all 4.
Front: 100 N/mm(572 lbs/in.)
Rear: 80 N/mm(458 lbs/in.)
ID ~65
Length 7.75 Inches
These came with my ohlins along with the Swift springs I put on them so these are just sitting around. Should work on multiple coilovers let me know if you need exact measurements. Brand new never used.
Attachment 76656
Attachment 76657
Attachment 76657

Top Secret Aragosta Coilovers SOLD SOLD SOLD
Ok I purchased these about 4 years ago from another member on here. They have 12k Swift Front spring and 11k Swift rear spring and come with a coilover wrench and nuts for the bottom bolt. These are pretty rare coilovers especially here in the US. Bulletproof had them listed for $4500 for a new set but they are no longer on their site.
I cannot find any evidence of leaks with these however I do not know just how many miles they have on them. I did talk with Bulletproof and it is possible to send them to Aragosta in Japan for a rebuild but from my research there is no one I can find in the US that can service these.
The main concern I have is on the rear coilovers the adjustment knobs do not stop turning no matter which direction you turn them in. This makes it nearly impossible to get the damping the same on both sides (also cannot tell if turning the knob is even adjusting anything at this point). The fronts work fine. This is the reason I am selling these so cheap. My car rode fine on them (they are a pretty stiff coilover) up until I took them off and put my Ohlins on. I want to stress that these are being sold AS IS and no refunds will be given. I will try and answer any questions you may have.

UPDATE 2/20: I have gotten some questions on these and have been to busy to properly clean and check them out so I hope this answers any questions there may be. I have taken the coilovers apart and cleaned them. Bump stops in front are in 2 pieces while the rears are 1 piece. I assume the fronts were at one time 1 piece but I honestly don't know. Before cleaning I could not find any evidence of them leaking. Now that they have been taken apart you will have to adjust the preload and height. Something else curious is the adjustment on the rears seems to have a hard stopping place now. I am not 100% sure the issue is fixed or what but they do stop. I am wondering f the knobs weren't in the right place or something and that was what caused them to spin. I don't want to make it seem like there is no concerns so it is still at your own risk.

Before Cleaning
Attachment 76659

After Cleaning
Attachment 76660

During Cleaning
Attachment 76661
Attachment 76662
Attachment 76663
Attachment 76664
Attachment 76665

Front Bump Stops
Attachment 76666
Attachment 76667

Rear Bump Stops
Attachment 76668
Attachment 76669

52mm Dual Gauge Pod sold
Has the OEM piece but you will need the little clips from your OEM one or buy new ones (part 91560-S84-A11 CLIP, PILLAR GARNISH (BLACK).

Wasp Front Spats sold
Bought these from another member on here an never installed. Good shape but has little nicks and what not.

AP1 Tail Lights SOLD
Passengers side is missing a tab and the drivers side has a spot that seems to be inside the lens. Overall decent shape but they are used. Would make a good project is you wanted to open them up.

EZ Motoring Extended Floor Mats SOLD
Used but still in good shape. These are discontinued. Steam cleaned and ready to go in your S2000.