WTB: OEM Rear Bumper
#1
WTB: OEM Rear Bumper
WTB: Looking to replace my cut-mesh bumper with an OEM one. Anyone in the area have one for sale? Would have to paint anyways so it doesn't need to be in perfect condition.
Last edited by silenc3x; 06-14-2018 at 09:51 AM.
The following users liked this post:
silenc3x (06-14-2018)
#5
Here ya go, doing this from my phone so he link don't work just copy and paste it, your welcome
https://newyork.craigslist.org/wch/p...613630773.html
https://newyork.craigslist.org/wch/p...613630773.html
#7
Community Organizer
Trending Topics
#8
it will be once I get a new one. I'll definitely sell it to you. I assume you have a BB? Would also be down for a swap.
It was cut by Ray ( S~Factor) from these forums, this thread in particular with my photos from 2011: https://www.s2ki.com/forums/new-york...547223/page28/
He also did my vented hood with mesh, and I had the black grillcraft. I have a different hood now though, so going back to stock on my bumpers, no mesh anywhere.
The vented hood (on both sides) turned out to be a total disaster, since rain from a heavy downpour got through the vented hood, into my brake line through the breathable cap, and cost me a few thousand replacing my whole brake system when my calipers seized. But that's a story for another day.
Ray did an amazing job, and it's in no way his fault since I told him what to cut. Hard lesson learned on my part.
It was cut by Ray ( S~Factor) from these forums, this thread in particular with my photos from 2011: https://www.s2ki.com/forums/new-york...547223/page28/
He also did my vented hood with mesh, and I had the black grillcraft. I have a different hood now though, so going back to stock on my bumpers, no mesh anywhere.
The vented hood (on both sides) turned out to be a total disaster, since rain from a heavy downpour got through the vented hood, into my brake line through the breathable cap, and cost me a few thousand replacing my whole brake system when my calipers seized. But that's a story for another day.
Ray did an amazing job, and it's in no way his fault since I told him what to cut. Hard lesson learned on my part.
Last edited by silenc3x; 06-14-2018 at 09:05 PM.