S9735

Hi Rega guys I need your help on some info to mount my 17*9 MP set.
The center bore of My 17*9 +38 MP set is about 65mm and i just found today that it neither fit the front hub nor cleared my spoon caliper.. kinda surprised cus I didn't meet such problem with my 16" SW388 many years ago, neither for CR93 I'm running now. Based on an old post on this thread said 17x8j +35 would clear spoon caliper without a spacer, can anyone confirm this again from own experience?
If that's a sure thing I'll have to change my 255 square set up to staggered. Appreciate if someone can help me out!

Dwayne_Fa5ias2k

im running spoon calipers with the 17x8 +35 wheel with no spacer it clears the caliper.

Mugen RR

Weight of Desmond Regamaster in 17x8 and 17x9? Thanks!

Grilla

My 17x8 MP is ~15lbs.

Feezy

I can check mine when i get them listed for sale, but they are very similar to the weights of the CE's. The Regas are just slightly heavier in my experience.

Ap2low

Anyone know the bore size of 17x9 +38 evos off the top of their head?

Feezy

If they are the same as the 8/9 +45 Regamasters it should be 73mm. I have some hubcentric spacers that are that size that fit perfectly into my Regamasters.

Ap2low

Yeah I wouldn't think it would vary that much from size to size. Awesome thanks Feezy, gonna try and find some hub rings

Feezy

Discount Tire. They sell Gorilla plastic hub rings. $5 for a set of four. You'll need two different sizes, but $10 is far cheaper than the $50+ I was seeing when I was looking for rings online.

Ap2low

Thats super cheap, so plastic ones would be better than aluminum? The cheapest once I found were from "touge-factory" on eBay for $17 but they were aluminum