Show me your painted valve covers
#202
By request, here are some installed pics.
VC11 by gccgoalie33, on Flickr
VC9 by gccgoalie33, on Flickr
VC10 by gccgoalie33, on Flickr
VC11 by gccgoalie33, on Flickr
VC9 by gccgoalie33, on Flickr
VC10 by gccgoalie33, on Flickr
#204
Looks like a lot of people painted the areas where the rubber seals and washers go for the bolts that go to the head. Was nobody else worried that paint flakes would get into the cylinder head from there?
Also alot of you have painted the breather port, again if powder gets into that port is nobody worried?
Also alot of you have painted the breather port, again if powder gets into that port is nobody worried?
#207
Went for the stock look, powder coated.. first color was "Wrinkle Red II" and it turned out to be such an awful choice, I had it redone with "Desert Crimson Red." Perfect. Prismatic Powders is the paint brand.
There are a couple of pieces still missing from engine install, but without the heat shield this is a good vantage point.
There are a couple of pieces still missing from engine install, but without the heat shield this is a good vantage point.
#210
Thread
Thread Starter
Forum
Replies
Last Post
AP1_s2k_noob
Texas - Central Texas S2000 Owners
17
10-05-2011 01:49 PM