JulieU

Finally got the MG-style CF hood to the body shop for repair and paint, so the TS-style hood will be up for sale very soon! A little bit about the TS-style hood:

• All the rain guards have been removed (I think I still have them tho... will have to look in the attic some time when it's not 100+° outside) and the bottom side has been dremeled in a few places where it had been rubbing on the valve cover, hood prop, etc.
• It has some minor hail dings.
• The forward section has clear bra on it which is a bit discolored now.
• Washer nozzles are not included.
• As with any aftermarket knock-off hood, fitment is not perfect and may take some modification.

I'll try to get some pix of it up on Saturday. Pix are below. Price? I guess $400 OBO.

HPCO$T

I have a brand new set gabe for sale

JulieU

These pictures were an attempt to capture the hood's imperfections. The hood is a little dusty.

One of the hail dings. Looks like just a little chip in the clear coat.
http://i10.photobucket.com/albums/a1.../DSCF-7549.jpg

Another hail ding. There's one more, but I couldn't get a good picture of it.
http://i10.photobucket.com/albums/a1.../DSCF-7550.jpg

Here you can sort of see the discoloration between the bare hood and the part that is clear bra'd. I can have the clear bra re-done if desired (buyer pays cost of both clear bra and installation).
http://i10.photobucket.com/albums/a1.../DSCF-7551.jpg

You can see the edge of the clear bra in this one. It illustrates how far up the clear bra goes.
http://i10.photobucket.com/albums/a1.../DSCF-7552.jpg

Close-up of discoloration.
http://i10.photobucket.com/albums/a1.../DSCF-7553.jpg

These three holes are the spots that were dremeled because it was rubbing on the valve cover and (AEM V2 cold air) intake tube. The reddish mark is another spot where it still rubs on the valve cover. :-/
http://i10.photobucket.com/albums/a1.../DSCF-7556.jpg

http://i10.photobucket.com/albums/a1.../DSCF-7557.jpg

This one was taken by a friend at the last Import Face-Off in Noble:
http://i143.photobucket.com/albums/r135/Ar...oblePics028.jpg

$400 OBO... SOLD to Suzuka_Joe. I'm not even gonna try shipping it, so pick up only.

Suzuka_Joe

hows the fitment julie? any larger gaps on one side or another?

JulieU

Enrique managed to get it pretty even actually. It took some modification of the latch to close though.

JulieU

Hood is now off the car and ready to be picked up.

JulieU

Another iPod cable added.

AFs2k

I think that valve cover is an AP2 one.

JulieU

Part # on the box says 12310-PCX-505. AP2 is 12310-PCX-010, I believe.

AFs2k

Yeah, but the hole for a PCV valve on an ap1 comes from the bottom - up, the PCV valve on an ap2 comes from the side - out like the one in your pic.

I will post pics shortly.

EDIT:


See, mine comes from the side - out, now go look at the one on your car.