One set of rear brakes doesn't have guide pin...still fine to use?
#1
One set of rear brakes doesn't have guide pin...still fine to use?
I just ordered a brand new set of EBC yellows all around, threw on the front just fine, moved to the rear got one done then noticed the other pair had no guide pin on it.
Is it still fine to run them? Or put the OEM back on?
Is it still fine to run them? Or put the OEM back on?
Last edited by steelers743; 05-16-2017 at 11:41 AM. Reason: added pic
The following users liked this post:
steelers743 (05-22-2017)
#4
Well I feel dumb and should have just read the directions....Apparently I got the set on the left and only one pad comes with a pin.
This chart just confused me more, it says the bumps "pips" fit in the piston but then it says one is on the fixed side. I just placed the ones with the pips on the piston side so it fits in the X of it.
Did I do it wrong? And does it even matter or do I just look stupid
This chart just confused me more, it says the bumps "pips" fit in the piston but then it says one is on the fixed side. I just placed the ones with the pips on the piston side so it fits in the X of it.
Did I do it wrong? And does it even matter or do I just look stupid
The following users liked this post:
steelers743 (05-22-2017)
Thread
Thread Starter
Forum
Replies
Last Post
mxt_77
Texas - North Texas S2000 Owners
10
11-12-2004 12:49 PM
HondaManR
Member S2000 Classifieds and For Sale
4
04-28-2003 07:43 AM