Looking for a Haltech map with ID1000's
#1
Looking for a Haltech map with ID1000's
I purchased a supercharger on here with the intentions of installing and getting it ready for tune.
Long story short, the blower was sent to vortech to get the oil slinger and other internals replaced...
I have already installed everything so I want to see if anyone can allow me to use their haltech map that has id1000s or something around that. I can adjust accordingly.
Current setup:
ID1000
Aeromotive 11142 fuel pump
stock fpr
Vortech V3
Currently teaching myself to use the haltech software so it would also be good to compare maps.
Long story short, the blower was sent to vortech to get the oil slinger and other internals replaced...
I have already installed everything so I want to see if anyone can allow me to use their haltech map that has id1000s or something around that. I can adjust accordingly.
Current setup:
ID1000
Aeromotive 11142 fuel pump
stock fpr
Vortech V3
Currently teaching myself to use the haltech software so it would also be good to compare maps.
#3
I was just trying to make changes to the AP1 stock map from the haltech site. Problem is that when I changed the injector size to 1000cc, and the dead time to what haltech recommends, it wasn't what I was expecting. When I tapped the throttle, it would get super rich. I'm new to this, so was there something I was missing? Do I have to actually make adjustments to the table?
Also, I did not have the o2 sensor connected because I am waiting for my aux connector from haltech so I can connect my wideband to the haltech. This should be done tomorrow.
Thread
Thread Starter
Forum
Replies
Last Post