trim pot/potentiometer wiring with AEM series 2
#1
trim pot/potentiometer wiring with AEM series 2
So gonna use one of these to have selectable boost...
Instructions say it needs +5v in (red), ground (black), and signal out (white).
Based on pinout... I'm gonna use D connector for: +5v in @ D6, ground @D9... where should the signal go? Maybe D8- supraforums says it needs to use the correct pull up I'm confused on this one. Any help/confirmation of the above would be great- thank you!
Link to supraforum info: http://www.supraforums.com/forum/sho...ition-trim-pot.
Diagram here: http://aemelectronics.com/files/instructions/30-6052%20Series%202%20Plug%20&%20Play%20EMS.pdf
Thanks in advance! Project's almost ready for a tune
Instructions say it needs +5v in (red), ground (black), and signal out (white).
Based on pinout... I'm gonna use D connector for: +5v in @ D6, ground @D9... where should the signal go? Maybe D8- supraforums says it needs to use the correct pull up I'm confused on this one. Any help/confirmation of the above would be great- thank you!
Link to supraforum info: http://www.supraforums.com/forum/sho...ition-trim-pot.
Diagram here: http://aemelectronics.com/files/instructions/30-6052%20Series%202%20Plug%20&%20Play%20EMS.pdf
Thanks in advance! Project's almost ready for a tune
Last edited by DrJimmyV; 10-17-2017 at 04:23 PM.
Thread
Thread Starter
Forum
Replies
Last Post
riceball777
S2000 Forced Induction
3
01-26-2011 06:21 AM