USDM DBW ECU Swap into International DBW AP2
#1
Registered User
Thread Starter
USDM DBW ECU Swap into International DBW AP2
Good day,
Just looking for a bit of help.
I am from South Africa and I own a 2008 S2000 which is a dbw f20c2.
Current mods:
K&N FIPK
Headerback Local Exhaust.
The current ecu in the vehicle is 37820-PCX-U08.
I have since purchased a USDM 37820-PZX-A14 ECU.
I wish to remove the South African ECU and install UDSM ECU.
Reason for swap is so as to get a Hondata flashpro working.
The UKDM ECU is the same as our South African ECU, as Honda Dealer in SA gave me a UKDM part number as replacement ECU when I inquired with them.
You may ask why did I source a USDM and not UKDM, I couldn't find a supported UKDM ECU at the time.
Questions:
Has anyone done this before to get the flashpro working?
What do I have to disable on the USDM ECU to get this working, i.e. no CEL?
Are there any Etunes, that I can use to get this working.
Any help regarding this will be appreciated.
Regards
Nitesh.
Just looking for a bit of help.
I am from South Africa and I own a 2008 S2000 which is a dbw f20c2.
Current mods:
K&N FIPK
Headerback Local Exhaust.
The current ecu in the vehicle is 37820-PCX-U08.
I have since purchased a USDM 37820-PZX-A14 ECU.
I wish to remove the South African ECU and install UDSM ECU.
Reason for swap is so as to get a Hondata flashpro working.
The UKDM ECU is the same as our South African ECU, as Honda Dealer in SA gave me a UKDM part number as replacement ECU when I inquired with them.
You may ask why did I source a USDM and not UKDM, I couldn't find a supported UKDM ECU at the time.
Questions:
Has anyone done this before to get the flashpro working?
What do I have to disable on the USDM ECU to get this working, i.e. no CEL?
Are there any Etunes, that I can use to get this working.
Any help regarding this will be appreciated.
Regards
Nitesh.
Thread
Thread Starter
Forum
Replies
Last Post