98tadriver

I didn't see a drag racing section, so I figured I'd post my videos in the gallery. Save "the s2000 isn't meant for 1/4mile," for someone who cares lol. I love drag racing & will drag race anything that I own. I'm actually going to NJMP this week for some twisties too.

video from outside-
same video from inside-
12.9 with bolt ons before the end of this season? Quite possible

Bolt ons, tuned by me with AEM ems2

JUSTINTHECOASTIE

Awesome job! However, the correct place to post is in the "Street Encounters" forums

98tadriver

Thanks!
Really? Even though it's at Atco Dragway? Lol. I'll have to take a look over there.

JUSTINTHECOASTIE

Yes. There is even a sticky thread for the drag strip times/traps

Mijae007

Interesting launch technique dropping it at redline...the launch pad mustve been really sticky. Nice run tho! Not easy getting into low 13s n/a.

98tadriver

duely noted lol. thanks for the heads up


Thanks! I give it a quick slip off the 2step (9,000ish rpm). I'm becoming more consistent but I feel like there's still a lil more room for improvement. If I let the clutch out too fast, it will bog worse(not much available torque lol).

Lex

Nice job! What were the actual bolt on's?

98tadriver

thanks! I have a Custom 3.5" over-the-radiator style cai with velocity stack, 69 or 70mm tb, intake mani matched to it, plm header, 3" exhaust pipe w/ 3" resonator reduced to a 2.5" muffler (i have a 3" muffler on it now) tuned by me with Aem ems2. Stock Ap1 trans, driveshaft and 4.10 rear. Act clutch with resurfaced factory flywheel.

I put the stock tb back on bc of the larger tb blade sticking a little, causing a high idle. Ran at Cecil County Dragway this past wednesday and ran a hundredth quicker. 13.23 @ 104.27 mph 1.94 60' bogged slightly on launch. Backed it up with another 13.23@104.6mph on a 2.00 60' slipping the clutch just a lil too much . I think I could have seen a 13.11 that night. DA was around 600' above sea level