wowwitsgau

How did you do the custom molding on the bumper to fender? Just curious what the process is like since I want to go down that route in the near future

Nippon

The molding was done by a body shop. The Spoon and the J's fenders don't match up to both width AND angle. The body shop used the J's fender extensions, cut them to form and them molded them to the spoon bumper. It was impressive to watch. I had the same work done for the rear J's overfenders. The J's overfenders are flat and traditionally fit AP1 rear bumpers which also have flat sides. The body shop was able to symmetrically mold both left and right overfenders to match the AP2 bumper lines.

jonner