f23power

hey everyone...about 7 months ago AEM used my car to research and develop an intake specifically for the 2006+ s2000. they contacted me last week saying that it was finally in production. looking at their website..i do see a small difference in the DBW specific intake compared to the non-DBW intake. it looks like the filter inlet is placed toward the nose of the car instead of the wheel well..i will be taking my car to AEM to install in a few hours.

2006+DBW s2000 Intake


Non DBW s2000 Intake


Installed:




overall..the power band is smoother and the motor doesnt feel like its struggling at the highend. i like how the filter is directly in the front grill. i may fab a splash guard eventually. was it worth it? YES!

-a

s2k aok

so it's in the engine bay and not the wheel well? do you have the new version in your car?

Catahoula01

Pics or this thread is worthless....!!!

Rubn1out4GudLuk

Looks like the filter ends up right behind the center grill of the ap2 bumper. Then you gotta make 2 holes? One to get it in the wheel well and another to get it out of the wheel well and into the center section behind the center grill. I'd like to see this on an S with the front bumper off to see how the intake wraps around the frontal area. Is this intake carb approved?

the s2k dude

u gonna sell ur piece alvin?

alSpeed2k

Are they going to test fit the final product in your car?

99SH

From AEM:

21-690C Product Specifications

Product Style: AEM Cold Air Intake System
Estimated Horsepower Gain: 7.67 HP @ 7300 RPM
Color: Gunmetal Gray
Replacement Filter: 21-2113DK
CARB Exempt: No
TUV Approved (Europe): No
Weight: 10.8 lb (4.9 kg)
Product Box Length: 35.5 in (902 mm)
Product Box Width: 13.25 in (337 mm)
Product Box Height: 10.5 in (267 mm)

TheLast13

CARB exemption usually takes a while to go through, Im sure it will be soon enough

S2000 CR

Finally its available, too bad I already have an intake.

f23power

i just had it installed at AEM. CARB paperwork has been submitted now pending.

-a