Berk Tech Test Pipe Good or Bad
#41
Registered User
Join Date: Mar 2007
Location: Gray/Johnson City
Posts: 637
Likes: 0
Received 0 Likes
on
0 Posts
The angles the flanges were welded on were off so it angled the drivers side tip further out. After I replaced it with the cat again the medalion touring exhaust lined up perfectly. If I were under the car and pulled the end of the exhaust to the drivers side I got the same results. one tip went in and angled to the pass. side and the other went out and angled to pass. side.
#42
Registered User
Join Date: Aug 2006
Location: Anaheim, CA
Posts: 887
Likes: 0
Received 0 Likes
on
0 Posts
the side that mounts to the header is designed to be somewhat flexible. if it was slightly off it should have be able to adjust itself on that flange. maybe yours wasnt made right. i would call berk and see if they can do anything about it.
#43
I just installed my Invidia dual catback system.
I have a Invidia testpipe with some extra mounting for the 02 sensor they sent me along with it to prevent the CEL. I was complaining to the guy about the possibility of the CEL sohe sent me some 02 mounting kit.
I did not run the test pipe and have it new in box because Im worried about an potential harm I may do to my engine if its running too rich or too lean and my computer is not reading it properly.
Where can I find a race free flow cat system???
Thanks
I have a Invidia testpipe with some extra mounting for the 02 sensor they sent me along with it to prevent the CEL. I was complaining to the guy about the possibility of the CEL sohe sent me some 02 mounting kit.
I did not run the test pipe and have it new in box because Im worried about an potential harm I may do to my engine if its running too rich or too lean and my computer is not reading it properly.
Where can I find a race free flow cat system???
Thanks
Thread
Thread Starter
Forum
Replies
Last Post