Rockin S2K

Hello,

I am looking to get some black or carbon fiber emblems like the picture below. I saw the YouTube video on how to DIY but that is to much work for me. I am ready to buy if anyone has an extra set or can point me the right direction. Thank you.

Midnightdennis

The diy is not that hard. I think you can get some on Ebay but you should verify the size.

Rockin S2K

I looked all over eBay and could not find any. I might end up doing them but I think it is so much work for something I think you could easily buy.

Deckoz

you just need to replace them all with black chrome badges or black CR badges

B serious

You've considered spray paint?

silenc3x

I have the same thing. You just buy new emblems for front and back: 75700-S2A-J00 and 75701-S2A-J00 and then spray em with a flat spray paint. Biggity bam, done in no time. It will literally take you 10 minutes tops if you hit em with 2-3 light coats of paint. You won't find similar mass produced emblems like that for sale. DIY is necessary.

hecash

I second and third the spray paint approach. Just buy the OEM stuff, rough the surface with 200 grit sandpaper and paint it semi-gloss or flat black. That's what I did.

Kyle

Thirded....just buy a set of new OEM emblems or cheap eBay ones that fit your car (plastic is plastic....) and scuff them and shoot them with some Krylon or something of the sort. As far as removing the emblems is concerned it takes literally minutes to remove the front and rear emblem......The rear is easily accessible through the trunk to unclip the push pins after you've dental flossed it, front is a little more difficult due to the pins having a press clip on the other side...either reach behind with some snippers or just break the OEM emblem off of the bumper. This whole process requires maximum like 30 or so minutes of your time and is incredibly simple....

silenc3x

Another one to join the powder coated exhaust tips club! Noice. Looks great.

jackmugen02

Carbon fiber H emblems: https://www.facebook.com/Aerospecracing/