Marrad ST3 install
#13
Registered User
Thread Starter
Thank ya sir. Ill take some pix and add em to the review. The wing "kisses" the door when the door is closed, but I dont think it affects door closure.
#15
That's a really nice looking seat, I wish Recaro could have made the upper harness holes like that.
The way you mounted the buckle seems a bit unsafe though?
Should at least pull it up fully so there i no gap under the bolt, a fitting rear seat buckle from another car would probably be best though.
The way you mounted the buckle seems a bit unsafe though?
Should at least pull it up fully so there i no gap under the bolt, a fitting rear seat buckle from another car would probably be best though.
#16
Originally Posted by marrad' timestamp='1468860941' post='24019258
I can sell the PCI brackets, with or without sliders, in combination with a seat. Email me what you're looking for and I will provide a quote.
Mark
Mark
Also, how does the lumbar options work?
I have two upholstery factories working on patterns to quote custom covers, but since all the seats I have come covered, you're paying for re-upholstery.
#17
Registered User
Thread Starter
Good call. Ill take a look at pulling the buckle up fully. I heard a mazda 626 receiver may work, need to do more research.
#18
Originally Posted by flanders' timestamp='1468880476' post='24019576
The way you mounted the buckle seems a bit unsafe though?
Should at least pull it up fully so there i no gap under the bolt, a fitting rear seat buckle from another car would probably be best though.
Should at least pull it up fully so there i no gap under the bolt, a fitting rear seat buckle from another car would probably be best though.
My link
#19
I thought the whole point of this abe, private label seat is so you could retain use of the factory receptacle? I would have found a better seat rail that could accomodate that.
#20
Is the seat actually any lower than the stock seat? It's difficult to tell from your pictures.
I used to have an SPG on Buddy Club rails and it could get low - I'm 5'10" all torso. Really interested in these as a replacement for stock seats, mostly for daily driving to get lower.
I used to have an SPG on Buddy Club rails and it could get low - I'm 5'10" all torso. Really interested in these as a replacement for stock seats, mostly for daily driving to get lower.