My ORTIZ CUSTOM POD story
#11
Site Moderator
Cover, Column (Upper) *NH167L* (Graphite Black) - Honda (77350-S2A-003ZA . $13.24 + shipping from Majestic.
Pods appear to be this style but there is a lot of variations available so you could easily pic the one that matches the gauges you bought. The wiring would still need to go down into the cover as well which would require some additional modding to run the wiring.
Plenty of other pod variations here.
Pods appear to be this style but there is a lot of variations available so you could easily pic the one that matches the gauges you bought. The wiring would still need to go down into the cover as well which would require some additional modding to run the wiring.
Plenty of other pod variations here.
#12
Summary.
Ortiz sucks, don't use them.
I figured out a cool, easy way to diy. But I won't share how I did it. Just tease you with my mad fab skilz. See how awesome that came out? Good luck trying to figure out what parts I used or how I did it, suckers!
Ortiz sucks, don't use them.
I figured out a cool, easy way to diy. But I won't share how I did it. Just tease you with my mad fab skilz. See how awesome that came out? Good luck trying to figure out what parts I used or how I did it, suckers!
#13
Thread Starter
Sensors installed: Oil Press, Oil Temp, Water Temp, Boost
Engine Harness: Built and wired for output
Gauge Pods: Gauges installed and wired
Internal Gauge Wiring: Wiring diagram set
To Do: 1) Install AFR when it arrives, 2) Build under dash harnesses a) sensor distribution; b) ignition on power distribution
Last edited by hecash; 08-01-2018 at 04:05 PM.
#17
Holy gauges batman! lots of props for going that route. i took the cleaner alternative.
Sos nsx screen
oem nav bezel
gauge art controller
everything uses aemnet, all wires run to the expansion plug on the aem. WAAAAY WAAAAY simpler and probably cheaper too.
also since my kit is tied to the ecu, i can data log all sensors directly off the ecu
Thread
Thread Starter
Forum
Replies
Last Post