Kpro4 to AIM solo DL data feed tutorial
#11
Originally Posted by andrewhake' timestamp='1467266368' post='24005751
[quote name='King Tut' timestamp='1464704696' post='23980770']
I have yet to see what an AIM Solo DL hooked up to a 2006+ DBW car can produce.
I have yet to see what an AIM Solo DL hooked up to a 2006+ DBW car can produce.
Awesome you got this working with KPro!
[/quote]
I'd say that depends. There are 5 of use who use the solo. Some DL some standard $399. We've uploaded data while at lunch and it's obvious where each of us gain time on one another. I've personally found a few tenths through those ah ha moments.
I can see the data feed for oil temp and pressure more than paying for itself. Soy of us bought the canton pans with no data to support oil pressure or starvation. This will show you if any of that is needed. I spend $400 on an accusump because "better safe than sorry". This is proof. I'll be sending in my Kpro for the upgrade so I can log this data.
#13
Hi there 'anorexicpoodle'
I can't PM you as i'm a new user but could you please email me the firmware for the Aim Racestudio? I'm doing a similar thing but on a Aim MXS Strada dash and the Aim technician sent me to this thread.
My email is brenth@csbrokers.co.nz.
Thanks a lot
I can't PM you as i'm a new user but could you please email me the firmware for the Aim Racestudio? I'm doing a similar thing but on a Aim MXS Strada dash and the Aim technician sent me to this thread.
My email is brenth@csbrokers.co.nz.
Thanks a lot
#15
#18
So, I've been trying to get my Solo2DL to read from Kpro my analog channels... but can't find a way to display them properly. Can't even find a way to change/edit the channels within the ECU Stream.
How did you get those sensors to display? I have PLX sensors outputting to the Kpro analog header (and the digital header)....
How did you get those sensors to display? I have PLX sensors outputting to the Kpro analog header (and the digital header)....
#19
So, I've been trying to get my Solo2DL to read from Kpro my analog channels... but can't find a way to display them properly. Can't even find a way to change/edit the channels within the ECU Stream.
How did you get those sensors to display? I have PLX sensors outputting to the Kpro analog header (and the digital header)....
How did you get those sensors to display? I have PLX sensors outputting to the Kpro analog header (and the digital header)....
Without that you will just get voltages. Fortunately on the solo2DL you can now build a custom canbus library and do the sensor conversions there.
Unfortunately Kpro exports the analog voltages as integers and not the native units from the kpro, so you need to build the conversion in both places.
#20