How do you push a pin out of a Honda Connector?
#1
How do you push a pin out of a Honda Connector?
I'm trying to push the Vehicle Speed Sensor wire crimped pin out of the connector and I haven't had any luck getting the tab inside the connector free. Does anyone know if there is a special tool or method to push the tab inside the connector? I know people usually just cut the wire for the top mod, but I'd rather just push it from the connector in case I want to reconnect it later. Here are two pics of the one I'm referring too. I'd appreciate any advice. Thanks!
#4
I did this. It was a royal pita trying to figure out exactly where to press, where the retaining tang was. I found detailed instructions in some thread on this forum, and I've this sort of thing removing a wire from a harness, but I still couldn't find that tang.
I spent way too long futzing with it, but finally got it. Once I got the tang, it just slipped right out. Wish I could remember where the tang was, to offer you some help...
I spent way too long futzing with it, but finally got it. Once I got the tang, it just slipped right out. Wish I could remember where the tang was, to offer you some help...
#5
Thread
Thread Starter
Forum
Replies
Last Post