I own a 20002 S2000. The seats were stolen and I bought replacement seats from a reputable salvage yard. They are in excellent condition except that the metal plate on the bottom of the seats is rusted because water had collected on the floorboard. The rust has caked a little, but the part is not rusted through. I could replace the metal plate with a new one or sand off the rust and prime it to prevent the rust from reoccurring. Has anyone done this? If so, how difficult is it to replace the plates? I called a local dealership and they said that the entire bottom seat had to be disassembled to replace them. I hope this is not the case. Any suggestions or guidance would be appreciated. If you wish, please e-mail me at: kandjatlanta@yahoo.com

Thanks!

 

So, what is the S2000 like in 20002?

 

i think it would be possible to do it yourself. look in this thread about lowering seat rail to see what's down there. good luck.

 

I'd think you could just sand it clean and primer it. It not like you'll ever see it once you install the seats.

 

Have it sandblasted,primer it,and paint it.!!!((black))