Did I Push this transmission seal in too far?
#1
Did I Push this transmission seal in too far?
I am trying to finally finish up my secondary shaft bearing replacement and now fear that I have pushed in the rear oil seal on the back of the tail shaft in too far. It is only a few mils but I am not sure exactly how to interpret the service manual range. Will this leak?
#2
When I replaced my output shaft oil seal (gearbox on car) last year I also inserted mine a bit too far, even though I was careful to tap it in bit by bit and measuring every time I still pushed it in about 1-2mm too far.
It has been fine however no leaks or issues
It has been fine however no leaks or issues
Thread
Thread Starter
Forum
Replies
Last Post
Mans Best
UK & Ireland S2000 Community
0
10-22-2003 02:53 PM