Question about head machining service marks
09-11-2018, 01:57 PM
#11
max oem is .25mm,
think its been honed correctly ? if not, then ring gap may not be correct?
also
thought all oem stuck out the top
also..
if using .25 mm the head needs a radius <.25 larger>that would not cause heating issues though.
think its been honed correctly ? if not, then ring gap may not be correct?
also
thought all oem stuck out the top
also..
if using .25 mm the head needs a radius <.25 larger>that would not cause heating issues though.
Thread
Thread Starter
Forum
Replies
Last Post
