So, I am in the process of changing my clutch out. I am almost ready to drop the subframe.

I am following the clutch DIY on S2Ki and some YouTube videos. Links here:

-DIY
https://www.s2ki.com/forums/californ...ll-diy-779439/

-Video @ 5:52

I have removed the bottom bolt of the steering knuckle and loosened the top bolt of the steering knuckle. According to the DIY and video, I should be able to freely move the joint off the knuckle. Unfortunately, that isn’t the case for me. I can’t move the joint at all, even after spraying some PB.

Is there a specific way to get the joint free?

And I’ve watched a few other clutch DIY videos and I have noticed no mention of removing the steering shaft. Is this part truly necessary before dropping the subframe?

Here’s my picture of the steering knuckle. I labeled the bolts I’ve taken off/loosen with the blue arrows.

Any help would be great!

https://imgur.com/a/BJCdYPW

 

wiggle the steering wheel back and forth rapidly to break it free.

 

I had to use a long piece of pipe and carefully knock on the joint to get it loose.

 

Will try later today. I’ll report back!

 

If at first you don't succeed, shove harder.

Ifanything, that pb be done it's job