S2KI Honda S2000 Forums - Search Results

 
Search: Posts Made By: twohoos
Showing results 1 to 25 of 38
Search took 0.04 seconds.
05-03-2019, 10:54 AM
Replies: 8
Views: 458
Posted By VashTheStampede

Old oxygen sensors and you!

As our cars get older, and systems start to time out, we’re going to start to run into situations like the one I recently found. The pic attached to this is/was an OEM oxygen sensor with 113,000...
Forum: S2000 Talk
04-12-2019, 08:02 AM
Replies: 10
Views: 1,654
Posted By MechaGodzilla

Honda desperately wants your S2000! Saturday!

I got something in the mail today (like real mail, on a piece of paper) from a local Honda dealer that made me feel like I was James Veitch getting spam e-mail...

Dear *insert full name*,

I...
03-05-2019, 04:32 PM
Replies: 7
Views: 534
Posted By bgoetz

Review of Cobalt Friction Brake Pads

Hey guys, I have been using Cobalt Friction pads for a bit now and wanted to followup with a review of their pads. I have tried a few different brands and these are by far my favorite. I run the XR-2...
01-19-2019, 09:32 AM
Replies: 77
Views: 16,622
Posted By anorexicpoodle

The A052 is the new cheatonium tire. Everyone...

The A052 is the new cheatonium tire. Everyone that weve seen move from RE71R to the A052 is laying down new personal best times.

I have a large amount of AIM data (literally data from nearly...
Forum: S2000 Talk
12-06-2018, 01:58 PM
11-28-2018, 12:53 PM
Replies: 1
Views: 696
Posted By Car Analogy

S2000 Lift Kit

Introducing, the first ever S2000 Lift Kit...

I didn't want to lower my car, but did want the other advantages of such springs. Higher spring rates, progressive springs (less roll, more immediate...
11-19-2018, 07:07 PM
Replies: 23
Views: 8,631
Posted By AlpineFD

Just noticed the manual that came with the HKS...

Just noticed the manual that came with the HKS HYPER IV SP coilover kit list the leverage ratio as 1.50 front, and 1.49 rear.
which translates to motion ratio of front 0.667 and rear 0.67
11-13-2018, 04:37 AM
Replies: 35
Views: 5,054
Posted By Billman250

In 95% of idle cases, it is always IAC, or an IAC...

In 95% of idle cases, it is always IAC, or an IAC improperly serviced.

No cleaner is used, and will likely make it worse. Disassembly and freeing up the shaft is key.

There are special...
10-26-2018, 08:38 AM
Replies: 9
Views: 424
Posted By Billman250

Yes its leaking, as they all do when the fluid is...

Yes its leaking, as they all do when the fluid is not kept clean.

Suck out the fluid in the res, clean out with paper towels, then refill. Do it again in 3k miles, the leak will likely stop.
10-26-2018, 06:47 AM
Replies: 9
Views: 424
Posted By Billman250

Not necessarily. Your clutch is lightly dragging....

Not necessarily. Your clutch is lightly dragging. First and reverse are engaged to bring the mainshaft from 1000rpm to a stop. The dragging clutch makes this difficult.

Once on the road, the...
10-22-2018, 01:42 PM
Replies: 3
Views: 161
Posted By Billman250

P0420 is cat efficiency. You can put a...

P0420 is cat efficiency.

You can put a spark plug spacer on the rear o2 and fix it.
10-11-2018, 03:01 PM
Replies: 7
Views: 790
Posted By Billman250

I have put some oem PPs to the ultimate test. ...

I have put some oem PPs to the ultimate test.

Their track record for reliability, even high mile reused, has been 100%.

In comparison, I have seen multiple failures in top brands in under 10k...
09-08-2018, 03:25 PM
Replies: 5
Views: 606
Posted By Car Analogy

DIY spring rate tester - oem springs tested

I posted in another thread about the homebrew diy spring rate tester I built. There was a request to test some oem springs, to compare to the calculated spring rates from twohoos dissertation on...
09-07-2018, 07:17 AM
Replies: 19
Views: 1,786
Posted By Car Analogy

I've come to the conclusion it's the tune. Not...

I've come to the conclusion it's the tune. Not just the fueling, but more the throttle plate mapping.

The stock throttle plate mapping is very non linear. Which explains why dbw S feel much less...
09-03-2018, 06:05 PM
Replies: 4
Views: 1,105
Posted By Car Analogy

H&R Sport Springs - spring rate measured

H&R has never disclosed the spring rates for their Sport Spring lowering springs (their coilover kit for our cars are 345/345, these are not those springs). They say its because there is no agreed...
08-03-2018, 02:35 PM
Replies: 17
Views: 1,113
Posted By TonyTranAP1

well got everything replaced put freon back in...

well got everything replaced put freon back in after a 2 hour pull down AFTER a flush. looks like everything is working great. the pressures are still low and i weighed in about 12.2 oz roughly...
07-30-2018, 04:54 PM
Replies: 19
Views: 1,567
Posted By B serious

ah. fudge. Y'all are correct AF. My bad.

ah. fudge.

Y'all are correct AF. My bad.
Forum: S2000 Talk
07-27-2018, 06:52 AM
Replies: 15
Views: 1,613
Posted By amsfoto

My S2000 Saved My Life

I've been considering posting about the accident I had back in early March for months now. It pains me to look at photos or even re-live the experience...but I guess in a way I wanted closure & to...
06-25-2018, 01:37 PM
Replies: 5
Views: 283
Posted By Billman250

Did you change the trigger wheel behind the...

Did you change the trigger wheel behind the timing cover?

There is a small part list needed to make it run.
06-24-2018, 05:57 AM
Replies: 121
Views: 8,400
Posted By SpitfireS

https://cimg0.ibsrv.net/gimg/www.s2ki.com-vbulleti...

https://cimg0.ibsrv.net/gimg/www.s2ki.com-vbulletin/1201x509/ens3ck6_e828428619e4f393443b0ab5417f23b84c5eb3be.png...
06-23-2018, 08:32 PM
Replies: 121
Views: 8,400
Posted By ericmdub92

Okay so weird update... i'm still waiting on...

Okay so weird update...

i'm still waiting on my new map sensor and tie wrap housing to arrive from HondaPartsNow but in the mean time i wanted to record my MAP data vs RPM and see if...
Forum: S2000 Talk
06-19-2018, 10:59 AM
Replies: 22
Views: 1,776
Posted By silenc3x

S2000 Manuals, materials, tips, info - One central place.

I'm starting to see manuals and information get a bit harder to find lately. Because of this, I am setting up a little small website to keep track of all OEM manuals, service manuals, tips, tricks,...
06-16-2018, 09:14 AM
Replies: 17
Views: 3,910
Posted By Billman250

If you dont hone/prep the cylinders, the new...

If you dont hone/prep the cylinders, the new rings will not seat in. I guarantee your oil consumption will be even worse after a ring job without honing.
02-21-2018, 01:28 PM
Replies: 4
Views: 1,144
Posted By Slowcrash_101

The bearing shells do not make a perfect circle...

The bearing shells do not make a perfect circle in this engine. That's why the instructions say to measure bearing clearance, and crank journal runout. The circle is made by the oil film in in the...
Forum: Site Info
02-12-2018, 04:54 PM
Replies: 570
Views: 45,179
Posted By IB Jason

Thanks for the feedback, twohoos. As of right...

Thanks for the feedback, twohoos. As of right now, our forum software doesn't support the BBCode for tables, but I've passed along the suggestion to our tech team and we're looking into adding it in...
Showing results 1 to 25 of 38
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands