S2KI Honda S2000 Forums - Search Results

 
Search: Posts Made By: Billman250
Showing results 1 to 25 of 208
Search took 0.07 seconds.
06-23-2019, 12:51 PM
Replies: 1,828
Views: 328,560
Posted By Billman250

PM sent...

PM sent...
06-16-2019, 07:45 AM
Replies: 107
Views: 10,589
Posted By Billman250

Anyone who has tightened their filter by hand and...

Anyone who has tightened their filter by hand and not had it come off has been lucky.

By stating it is ok to hand tighten this unique filter is poor advice, as people follow that advice, and then...
06-16-2019, 05:15 AM
Replies: 36
Views: 3,510
Posted By Billman250

I never loosen the lock nuts. But it is critical...

I never loosen the lock nuts. But it is critical that the caps be pulled down carefully, and evenly, to avoid cracking the top caps.
06-15-2019, 07:59 AM
Replies: 36
Views: 3,510
Posted By Billman250

I have done countless retainer jobs, and never...

I have done countless retainer jobs, and never once have I blown out any of the holes. Some of those holes have oil coming up through them (the ones that control Vtec pressure) So I strongly believe...
06-12-2019, 11:16 PM
Replies: 36
Views: 3,510
Posted By Billman250

Did you use an over head spring compressor, or a...

Did you use an over head spring compressor, or a hammer-tool, to remove the cotters?

Compression test will not unearth bent valves at a small level, only a leak down test will do that.

Do do...
06-11-2019, 09:12 AM
Replies: 8
Views: 740
Posted By Billman250

They are fine, without even looking. You...

They are fine, without even looking.

You will bend valves long long before you can damage an AP2 retainer.
05-24-2019, 04:53 PM
Replies: 4
Views: 989
Posted By Billman250

Yes he’s been doing tires a very long time,...

Yes he’s been doing tires a very long time, killer machines.
05-15-2019, 08:48 AM
Replies: 1,828
Views: 328,560
Posted By Billman250

Sent you a PM (personal message)

Sent you a PM (personal message)
05-05-2019, 09:18 AM
Replies: 7
Views: 1,092
Posted By Billman250

If it’s built with aftermarket engine parts, find...

If it’s built with aftermarket engine parts, find another car.
04-26-2019, 05:34 AM
Replies: 52
Views: 4,873
Posted By Billman250

I assure you there is no damage in this instance.

I assure you there is no damage in this instance.
04-24-2019, 06:29 PM
Replies: 52
Views: 4,873
Posted By Billman250

Chances are high that the car is fine.

Chances are high that the car is fine.
04-17-2019, 06:33 PM
Replies: 6
Views: 438
Posted By Billman250

No abnormal noises there at all.

No abnormal noises there at all.
04-15-2019, 01:36 AM
Replies: 16
Views: 2,963
Posted By Billman250

Just PM me. PM sent.

Just PM me. PM sent.
04-11-2019, 03:57 AM
Replies: 30
Views: 1,704
Posted By Billman250

Exhaust valve-to-piston contact at 10,700. AP2...

Exhaust valve-to-piston contact at 10,700.
AP2 retainers on the exhaust side will lower that number

Yes you can do it. And yes Honda put them in AP1s overseas (they are not going to continue to...
04-01-2019, 10:37 AM
Replies: 5
Views: 304
Posted By Billman250

-Misfire at idle/all other areas are ok ...

-Misfire at idle/all other areas are ok

Valve adjustment is the first step.
04-01-2019, 06:10 AM
Replies: 7
Views: 596
Posted By Billman250

$20k ish with all original body panels, mint...

$20k ish with all original body panels, mint condition, no chassis corrosion.

Down to 12k for condition.
03-28-2019, 09:02 AM
Replies: 1,828
Views: 328,560
Posted By Billman250

PMs sent, thanks :thumbup:

PMs sent, thanks :thumbup:
03-21-2019, 01:08 PM
Replies: 6
Views: 371
Posted By Billman250

The entire transmission is built onto the bell...

The entire transmission is built onto the bell housing. Both shafts, and all the mounts for the shift shafts. A pic will make it clearer.

Slows2k is correct.

It can be done, but it all has to...
03-21-2019, 11:15 AM
Replies: 11
Views: 665
Posted By Billman250

A bad syncro cannot cause gear pop-out. It...

A bad syncro cannot cause gear pop-out.

It is either a bent fork (unlikely) or rounded teeth on the gear collar (most likely). Either way the trans has to come apart.
03-18-2019, 09:33 AM
Replies: 13
Views: 612
Posted By Billman250

Just get 4 known good packs. I have seen...

Just get 4 known good packs.

I have seen this first hand quite a few times (misfire heard/felt intermittently with no CEL)
03-18-2019, 06:11 AM
Replies: 36
Views: 3,964
Posted By Billman250

The bottom line is the chain tension. In the case...

The bottom line is the chain tension. In the case of mrpenis, he installed a ballade tct to attempt to cure a noise that was not a loose chain. If you don’t have the guide depth/chain wear to...
03-17-2019, 07:05 AM
Replies: 26
Views: 1,633
Posted By Billman250

Even on the most corroded S2000s, I have never...

Even on the most corroded S2000s, I have never seen a steel brake line failure or hose failure.

Here’s your chance to learn how to not get taken. How is the brake fluid level? Pop the hood and...
03-15-2019, 06:46 AM
Replies: 100
Views: 15,656
Posted By Billman250

That number is now in the thousands. Anyone...

That number is now in the thousands.

Anyone using anything other than Honda MTF to improve shift feel are only masking an underlying problem. It can go 30k miles in a street car, and perform as...
02-20-2019, 03:31 AM
Replies: 9
Views: 2,213
Posted By Billman250

Correct.

Correct.
02-19-2019, 03:33 AM
Replies: 20
Views: 924
Posted By Billman250

I was there with a guy with a bmw who woundnt...

I was there with a guy with a bmw who woundnt pass, he wired soda cans to the muffler and passed.
Showing results 1 to 25 of 208
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands