Honing FRM Sleeves
#1
Registered User
Thread Starter
Honing FRM Sleeves
What's up guys? Looking for a local shop to PHX/AZ that is comfortable honing FRM sleeves our motors come with. Throwing new piston rings into the block and want a clean sheet for the new rings to bed in properly. Already spoke to S & S down in Mesa.
The following users liked this post:
9kred (04-19-2019)
#6
Registered User
Thread Starter
I already did use them to have my head built. Talking to them regarding the bottom end and FRM sleeves, they didn't seem comfortable honing these sleeves. Not very confidence inspiring to say the least.. Dude from TSR was a different conversation. Has done many FRM sleeves and was recommended by multiple people. When I got there he had multiple Honda's he was working on as well. From my research as far as local goes, that seemed to be the route to go with.
Thread
Thread Starter
Forum
Replies
Last Post
SimbaDogg
California - Southern California S2000 Owners
9
06-02-2010 10:00 AM