First name: Mike
Price: 1500 obo
Location: Gloucester Point, VA
Contact: PM or DatsunDoc@aol.com

These are some Hytech cams I bought from John at Hytech for my race car. They are for a normally aspirated engine. The rules for my class require valve lift at less than 0.5" at zero lash and these were above that so I could not use them and the they have been sitting on a shelf in my shop. They are new condition and have never been run in an engine. They are ground on steel billets. Nice cams that have been shown to increase power over stock but I can't use them.

 

Wow, OT but you joined this forum in 2001 and only have 5 posts? You're doing better than me! (I actually have lurked here since 2004, but didn't "join" until 2010)

 

Yes, I just realized that too and laughed. I bought a S2000 in 2000 and joined shortly after that. It's been mainly a daily driver and kept stock all these 19 years so I didn't really have much to add. Over the past few years I've built another one just to race. That's how I ended up with the cams.

 

Do these come with and documentation or spec sheet?