Why must they have to point sideways???? Now everytime I come home I have to peel off the excess diffuser... Does anyone have this problem with this exhaust? Is there a way to get them more centered in the diffuser exits??

 

yes i had this problem with only one tip what I did was I brought it to an exhaust shop where he aligned it basically he cut a small section of the inner pipe where the muffler goes over the 't' on that side and put the muffler back in then he heated and bent a hanger. Go to a good echaust shop and theyll know how to do it.

 

How did you fix the diffuser so it didn't look so burnt where the tips touched it? If I center them now it's only gonna make them more noticeable lol

 

If you have an AP1 bumper you can use an AP2 hanger (fairly cheap from Honda) and use the long side to space it further than a regular AP1 hanger. If you are in an AP2 then you will probably be limited to an exhaust shop or if you trust yourself with a torch and your own ingenuity going that route.


PS, probably not the best idea to swear in a message title. Gets some bad attention.

 

Ballsy title lol, if you wanna go the cheap route, take some zip ties around from hanger and center of your bumper support and tighten so it moves around less and wont touch&burn ... did this to my skunk2 exhaust, and those things are insane angles.

 

Thanks I didn't even think of that! Definitely going to go down that route instead of paying someone 60$ to bend my exhaust lol

And sorry if the title is too much lol. I was pissed and I'm too used to the subaru and 240sx forums where everyone just yells at eachother.