Moddiction Titanium Shift Knobs!
#22
Former Sponsor
Thread Starter
Yeah I am deciding if I am buying the equipment to do it myself or send them out so once I figure that out won't be too long till I can get those going.
#23
Send me a PM when you get the anondized ones in.
#30
Former Sponsor
Thread Starter
Originally Posted by 8800EZ,Oct 26 2010, 04:45 PM
Any pics of these knobs installed? That brushed Ti looks nice.
I want to see how low it sits...
Gracias.
I want to see how low it sits...
Gracias.
It sits very low. Just as low as my current stainless steel shift knobs sit. The boot on my shift knob was cut on the top so that it would go lower down. My shift lever is cut about 1/2" however. It lowers the height by about 1". Should be the lowest sitting shift knob you can really buy. No 2" can go any lower unless the hole is drilled through the top lol.