Thread cutter ( thing !)
#1
Thread cutter ( thing !)
Just wondered if anyone in the Southampton area could help me out ....
would like to lower my gear stick down a touch . So I guess I need to rethread down the shaft a bit ( oo er) and cut a tad off the top ? Anybody have a implement to do this ?
Obviously will pay /beers
thanks
would like to lower my gear stick down a touch . So I guess I need to rethread down the shaft a bit ( oo er) and cut a tad off the top ? Anybody have a implement to do this ?
Obviously will pay /beers
thanks
Last edited by Bodyboarder1981; 02-06-2017 at 12:42 PM.
#2
you just want a deeper threaded knob ooer
guess you could shorten the stick and run a die down to extend the thread
i think people call them countersunk knobs - google it
guess you could shorten the stick and run a die down to extend the thread
i think people call them countersunk knobs - google it
#3
You might want to approach cutting the linkage down with caution. Not sure, but it might be hardened steel, in which case, you will 1) have "Fun" cutting through it and 2) have even more "Fun" cutting the new thread.
Im surprised you want it lower, as the S2000 gearstick does not exactly sit very high.
Good luck!
Im surprised you want it lower, as the S2000 gearstick does not exactly sit very high.
Good luck!
#5
Ok I'll scrap that idea then ! Already bought a gear knob from Si , a CR one ? Looks nice with yellow gear selector colour
Thread
Thread Starter
Forum
Replies
Last Post
Moddiction
S2000 Modifications and Parts
5
08-24-2009 07:45 PM
highwaystardoritos
Florida S2000 Owners
8
09-06-2007 02:13 AM