Mark this thread as Unsold
FS: Front bumper (facelift) brake ducts
#1
Thread Starter
Front bumper (facelift) brake ducts
Some months ago I designed/developed some brake ducts to fit sympathetically into the "faux brake ducts" in the front bumper.
background/install here:
https://www.s2ki.com/forums/uk-irela...ducts-1178825/
I've since tweaked the design here and there and now have just 3 pairs printed available for those that requested I sell them.
These are designed for 2" ducting, and angled to route under the air pump behind the bumper.
They obviously require cutting of the bumper and arch liner, and a flange be welded to the rear of the disc heat shield to receive the air pipe.
Mine are bonded to the bumper using black silicon.
For sale is just the 3D printed plastic bumper duct. Please bare in mind the surface finish on a 3D print is not as fine as a mass manufactured plastic component. They look good, but are not perfect.
They do however fit more discreetly in the bumper than anything else I've seen, and at about a 3rd of the price.
Mine have been on the car 18months now with no issue
£55 inc delivery.
background/install here:
https://www.s2ki.com/forums/uk-irela...ducts-1178825/
I've since tweaked the design here and there and now have just 3 pairs printed available for those that requested I sell them.
These are designed for 2" ducting, and angled to route under the air pump behind the bumper.
They obviously require cutting of the bumper and arch liner, and a flange be welded to the rear of the disc heat shield to receive the air pipe.
Mine are bonded to the bumper using black silicon.
For sale is just the 3D printed plastic bumper duct. Please bare in mind the surface finish on a 3D print is not as fine as a mass manufactured plastic component. They look good, but are not perfect.
They do however fit more discreetly in the bumper than anything else I've seen, and at about a 3rd of the price.
Mine have been on the car 18months now with no issue
£55 inc delivery.
Last edited by S2Bray; 04-06-2019 at 09:54 AM.
Thread
Thread Starter
Forum
Replies
Last Post