Hendy Performance Discount Codes & new brands listing!
#71
UK Trader
Thread Starter
The following users liked this post:
Si@Hendy Performance (08-16-2018)
#74
UK Trader
Thread Starter
Will do!
#76
UK Trader
Thread Starter
#77
am looking to get the necessary parts to do a full geometry alignment. I'm getting it done by Daytona Dave and he recommended you to get the parts. I'm a member of s2kuk so was hoping for a total on all the bits i need.
pls email
ric
Last edited by Richard Macintosh; 11-08-2018 at 08:30 AM.
#78
UK Trader
Thread Starter
hi
am looking to get the necessary parts to do a full geometry alignment. I'm getting it done by Daytona Dave and he recommended you to get the parts. I'm a member of s2kuk so was hoping for a total on all the bits i need.
pls email me at ................
thanks
ric
am looking to get the necessary parts to do a full geometry alignment. I'm getting it done by Daytona Dave and he recommended you to get the parts. I'm a member of s2kuk so was hoping for a total on all the bits i need.
pls email me at ................
thanks
ric
I'll drop you an email now - you may want to remove your email from the post!
#80
UK Trader
Thread Starter
Thanks for the message.
We have both versions in stock,
The Mugen Boss is discontinued but the Spoon one ( in stock ) will work perfectly fine and also come with the airbag resistor - https://www.hendyeshop.co.uk/mugen-s...3-298907-p.asp
https://www.hendyeshop.co.uk/mugen-s...1s0-7621-p.asp
https://www.hendyeshop.co.uk/mugen-s...3-298907-p.asp