Milltek Exhaust Group Buy - HendyPerformance
#381
UK Trader
Thread Starter
I have spoke to James here who sent them (he has rung Digits2k) we have the correct tips on there way out to you tomorrow, We only sent one HO210 exhaust out as we still have 3 out of 4 here. So there may be 1 other person with a set of round tips instead of ovals.
#382
I got mine in the USA today all I can say is THANKS so much for the group buy the exhaust is one of the best sounding with straight pipes. I checked and got oval tips I'm very pleased that is really all I can say.
The following users liked this post:
Si@Hendy Performance (04-19-2018)
#383
Yes, mine have arrived (weds) all accounted for and proper!
I must say it seems like these were slammed together as I'm sure their BMW //M or Audi exhausts are likely much nicer in the QC arena.
Not complaining much but compared to my Fuji exhaust the time spent creating the welds and the general "slag" on the piping is pretty bad.
Oh well, after they're installed and warmed up none of this will matter.
Thanks Si again..
I must say it seems like these were slammed together as I'm sure their BMW //M or Audi exhausts are likely much nicer in the QC arena.
Not complaining much but compared to my Fuji exhaust the time spent creating the welds and the general "slag" on the piping is pretty bad.
Oh well, after they're installed and warmed up none of this will matter.
Thanks Si again..
The following users liked this post:
Si@Hendy Performance (04-19-2018)
#384
Registered User
[left]I got mine yesterday after some mither with UPS haha!
I agree with the overall quality of the fine touches, my old Audi S3 milltek system just seemed to be a nicer quality.
But a killer system, big thanks to Si and Hendy Performance!
Big install tomorrow morning after I ceramic coat the tips tonight
I agree with the overall quality of the fine touches, my old Audi S3 milltek system just seemed to be a nicer quality.
But a killer system, big thanks to Si and Hendy Performance!
Big install tomorrow morning after I ceramic coat the tips tonight
The following users liked this post:
Si@Hendy Performance (04-20-2018)
#385
UK Trader
Thread Starter
We have re-checked the stock levels of each of the remaining kits today - and I'm 100% confident that only 1 system was sent out incorrectly to digits2k, he had his correct trims yesterday so we should all be fine now
#386
Cheers Si thanks for sorting me a o/s box very much appreciated this enabled me to make a single system using the oem centre section and the right hand rear box so i now have the system i wanted which is less than half the weight of the oem,
Db limits seem to be ok for hillclimbs and sprints
5K
6K
7K
Db limits seem to be ok for hillclimbs and sprints
5K
6K
7K
#388
#389
Hello,
I'd like to place an order but I prefer the dual oval tips. How I do I go about ordering one and to find out the total cost?
By the way, I'm in the U.S. and I have the AP2 model.
Thanks
SS
I'd like to place an order but I prefer the dual oval tips. How I do I go about ordering one and to find out the total cost?
By the way, I'm in the U.S. and I have the AP2 model.
Thanks
SS
#390
UK Trader
Thread Starter
We have 3 left.
Please order via the link below (VAT will be removed in the checkout once you select USA) - I'll PM you the group buy discount code now.
https://www.hendyeshop.co.uk/milltek...--218614-p.asp