CKit

Got a few PMs from people purchasing the unit. Thought I'd get around to posting an install DIY. Couldn't find my digicam, so will have to settle for crappy cell phone pix.


--CKit









"Scotchlok" T-taps. Put one wire through and one unstripped wire alongside.
Clamp the metal bridge down and lock the cover over and the wires are spliced together. Solder if you'd like for more stability. Cover with electrical tape.







You can tap into the ACC fuse or into the ACC power wire (green wire in diagram is tapped to power).

The ECU has three wiring harnesses. Front to back are "A," "B," and "C."
"A" has the blue #19 wire for the tach. "B" has the injector cut wires. You don't need to tap into the "C" harness. Refer to the wiring diagrams posted above for the coloring of the wires to splice into.








For the ABS wires, it doesn't matter which color wire goes to what ABS sensor.

NVMY4N

PM me when this is complete.

shinigamiz

i've already told you through PM, but i figured i will put it here as well. i have every intention of trying to do this install this week/end. thanks again for doing this!

NVMY4N

If you guys don't mind, please snap pics, and make a few notes.....or a bunch of notes

Thanks
Brad

asng

post pix. lots of them. i wanna see how you cut into the abs wires

squirrels2k

i too am very interrested in a diy

CKit

Some pictures posted. The ECU wires aren't labeled in the pictures yet.
Also have to get a picture of the ACC power and grounds.

But it should be a place to start.

CKit

PM with questions.

shinigamiz

very nice! i just printed the page so i could refer to your pictures.

an additional note, here are the pages for the wiring diagrams (from service manual for 2000-2006)
Connector A: 11-17
Connector B: 11-19
ABS: 19-37

TestaRossa

excellent write-up